Metrohm tiamo 2.3 Manual - Manual (Page 1244)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1228 ￭￭￭￭￭￭￭￭ tiamo 2.3
5.6.7.9.2 FLOW - Properties
Dialog window: Method ▶ FLOW ▶ Properties... ▶ FLOW -' Command name'
Command name
Name of the command.
Input 25 characters
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
Device type
Display or selection of the device type. If a device is selected under Device
name, then this Device type field can no longer be edited, and the
device type belonging to the selected device is displayed instead.
If the option not defined is selected as Device name, any device types
or device groups which are able to execute the command can be selected,
independently of the devices in the device table.
Selection 774 Oven Sample Processor | 874 Oven Sam-
ple Processor
Default value 874 Oven Sample Processor
Gas
Gas type
Gas type of the carrier gas.
Selection Air | Nitrogen | other gas
Default value Air
Gas flow factor
Factor for the correct determination of the gas flow. This parameter is
only visible for Gas type = other gas. The values for frequently used car-
rier gases are listed in the device manuals.