Metrohm tiamo 2.3 Manual User Manual
Page 1054
5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1038
￭￭￭￭￭￭￭￭
tiamo 2.3
Designation
Description
.BSY
Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
.DBL
Total duration for the processing of the command in
s
.EME
End measured value (measured value after processing
of the command) in the unit of the measured value
.ETE
1)
End temperature (temperature following processing
of the command) in °C
.FIN
Command status; 1 = Command has ended at
least once, 0, invalid (variable not available) =
Command has never ended
.FP{#}.[MEA]
Measured value for the fixed endpoint # (1…9) in
the unit of the measured value
.FP{#}.CNT
Intensity for the fixed endpoint x (1…9) in counts
.FP{#}.TEM
1)
Temperature for the fixed endpoint # (1…9) in °C
.FP{#}.TIM
Time for fixed endpoint # (1…9) in s
.FP{#}.TRN
Transmission for the fixed endpoint x (1…9) in %
.IME
Initial measured value (measured value before start
conditions are processed) in the unit of the measured
value
.ITE
1)
Initial temperature (temperature before start condi-
tions are processed) in °C
.LP.CAx
Calculated value × (1...3) for the last measuring point
on the measuring point list
.LP.CNT
Transmission of the last measuring point of the
measuring point list in %
.LP.EXx
External value × (1...3) for the last measuring point of
the measuring point list
.LP.MEA
Measured value for the last measuring point of the
measuring point list in the unit of the measured value
.LP.TEM
1)
Temperature for the last measuring point of the
measuring point list in °C
.LP.TIM
Time in s until the last measuring point in the meas-
uring point list is reached