Metrohm tiamo 2.3 Manual - Manual (Page 617)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 ￭￭￭￭￭￭￭￭ 601
Selection maximum
Start slope
Note
Only displayed for Titrando and 855.
Start slope
When the start slope is reached the dosing of the start volume is stopped
and the titration is started. If the start slope is achieved by the dosing of a
start volume then the titration starts directly.
Range 0 ... 999 mV/mL
Selection off
Default value off
Dosing rate
Speed at which the start volume is added until the start slope is reached.
The maximum dosing rate depends on the cylinder volume of the
exchange unit or dosing unit used.
Range 0.01 ... 166.00 mL/min
Default value 5.00 mL/min
Selection maximum
Pause
Pause
Waiting time, e.g. for the electrode to settle down after the start or a
reaction time after the addition of the start volume. The pause follows at
the end of all the start conditions.
Range 0 ... 999999 s
Default value 0 s
5.6.3.3.3.4 MET U - Titration parameters
Tab: Method ▶ MET U ▶ Properties... ▶ Titration parameters
Command name
Name of the command.
Input 25 characters
Parameters defining the run of the titration.