Metrohm tiamo 2.3 Manual - Manual (Page 487)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 ￭￭￭￭￭￭￭￭ 471
5.6.3.2.2.5 DET pH - Stop conditions
Tab: Method ▶ DET pH ▶ Properties... ▶ Stop conditions
Command name
Name of the command.
Input 25 characters
Conditions for stopping the titration. If more than one stop condition is in
effect at the same time, then the criterion which is fulfilled first will stop
the titration.
Stop volume
Stops when the given volume has been added after the start of the titra-
tion (including start conditions). The stop volume should be adapted to
suit the sample weight or the titration vessel size.
Titrando, 855
Range
0.00000 ... 9999.99 mL
Default value 100,000 mL
Selection off
Titrino
Range
0.000 ... 9999.99 mL
Default value 100.00 mL
Selection off
Stop measured value pH
Stops when the preset value for a measuring point has been exceeded or
not achieved since the start of the titration.
Titrando, 855
Range
-20.000 ... 20.000
Selection off
Default value off
Titrino
Range
-20.00 ... 20.00
Selection off
Default value off
Stop EP
The titration is stopped when the specified number of equivalence points
has been found.
Range 1 ... 9
Default value 9