Metrohm tiamo 2.3 Manual - Manual (Page 1243)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 ￭￭￭￭￭￭￭￭ 1227
Init.temp.
With Init.temp. the cuvette heating is switched on at the same time
as the device and the cuvette is heated up to this temperature. The ini-
tial temperature is entered and altered in tiamo.
off
Switch off the heater.
5.6.7.9 FLOW
5.6.7.9.1 FLOW - Overview
Dialog window: Method ▶ FLOW ▶ Properties... ▶ FLOW - 'Command name'
Command for controlling the gas flow.
Devices
This command can be executed with the following devices:
Sample Processor: 774, 874
Appearance
The command has the following appearance:
Parameters
The parameters for the command FLOW are configured in the following
dialog window:
￭ FLOW - Properties
Command variables
The following command variables are generated in the method run by the
command FLOW and can be used in formulas under the designation
'Command name.Variable designation':
Identifi-
cation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
not ever been started
.FIN Command status; 1 = Command has been ended at
least once, 0, invalid (variable not available) = Com-
mand has never been ended