Metrohm tiamo 2.3 Manual - Manual (Page 400)

4.8 Subwindow Curves ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
384 ￭￭￭￭￭￭￭￭ tiamo 2.3
For CAL Spec-commands
Selection
Wavelength [nm] | Intensity [Counts] | Satura-
ted pixels
Default value Wavelength [nm]
Label
Freely definable axis label for the x axis. With auto the designation from
the field Size will be used.
Selection 50 characters | auto
Default value auto
Scaling
Start value
Initial value for scaling the x axis.
Only editable when autoscaling is deactivated.
Range
-1.00E+12 ... +1.00E+12
Default value -1.00E+12
End value
End value for scaling the x axis.
Only editable when autoscaling is deactivated.
Range
-1.00E+12 ... +1.00E+12
Default value +1.00E+12
4.8.4.3 Curve properties - y1 axis
Tab: Database ▶ Curves ▶ Properties curves # ▶ y1 axis
Parameters for the graphical display of the curves on the y1 axis (left-hand
y axis).
Command type
Selection of the command type for which the curve properties are to be
defined. The curve properties defined for each command type are saved
per curve window and per client.
Selection DET | MET | SET | MEAS | MEAS T/Flow | MEAS
TC Cond | MEAS Ref | MEAS TMF | MEAS Spec
| MEAS Opt | CAL Spec | KFT | KFC | BRC | STAT
| DOS | TET
Default value DET