Metrohm tiamo 2.3 Manual - Manual (Page 1109)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 ￭￭￭￭￭￭￭￭ 1093
Identifica-
tion Description
.DBL Total duration for the processing of the command in s
.EME Final measured value (measured value after processing
of the command) in the unit of the measured value
.ETE End temperature (temperature following processing of
the command) in °C for the last measurement
.FIN Command status: 1 = Command has been ended at
least once, 0 = Command was started but not
ended, invalid = Command was not started (varia-
ble not available).
.IME Initial measured value (measured value at the start of
the command) in the unit of the measured value for the
last measurement
.ITE Initial temperature (temperature before processing of
the command) in °C for the last measurement
.LP.MEA Measured value for the last measuring point in the
measuring point list in the unit of the measured value
.LP.TEM Temperature for the last measuring point of the measur-
ing point list in °C
.LP.TIM Time in s until the last measuring point in the measuring
point list is reached
.MTE Temperature measurement with sensor; 1 = on, 0 =
off)
.NMP Number of measuring points in the measuring point list
.RTE Reference temperature in °C (only MEAS Cond and
CAL Cond)
.STY Type of stop with which the command was stopped: 1
= stopped normally, 0 = stopped manually with
[Quit] or [Stop].
.TC Temperature coefficient in %/°C
5.6.5.4.2 CAL Cond - General/Hardware
Tab: Method ▶ CAL Cond ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Input 25 characters