Metrohm tiamo 2.3 Manual - Manual (Page 689)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 ￭￭￭￭￭￭￭￭ 673
Designation Description
.LP.TIM Time in s until the last measuring point in the
measuring point list is reached
.LP.VOL Volume for the last measuring point in the measur-
ing point list in mL
.MA.MEA Maximum measured value in the unit of the meas-
ured value
.MA.TEM Temperature for the maximum measured value in
°C
.MA.TIM Time in s until the maximum measured value is
reached
.MA.VOL Volume at maximum measured value in mL
.MI.MEA Minimum measured value in the unit of the meas-
ured value
.MI.TEM Temperature with minimum measured value in °C
.MI.TIM Time for the minimum measured value in s
.MI.VOL Volume at minimum measured value in mL
.MTE Temperature measurement with sensor; 1 = on, 0
= off)
.NMP Number of measuring points in measuring point list
.RTE Reference temperature in °C
.SME Start measured value (measured value after pro-
cessing the start conditions) in the unit of the
measured value
.STE Start temperature (temperature after processing of
the start conditions) in °C
.STY Type of stop with which the command was stop-
ped: 1 = normal; 0 = manual or after error
.SVA Start volume absolute (volume that was added
according to the start condition "start volume") in
mL
.SVM Start volume measured value (volume which was
added according to the start measured value given
in the start conditions) in mL
.SVS Start volume slope (volume that was added accord-
ing to the start condition "start slope") in mL