Metrohm tiamo 2.3 Manual - Manual (Page 1047)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 ￭￭￭￭￭￭￭￭ 1031
￭ Measuring parameters
Parameters for setting the measurement procedure.
Command variables
The following command variables are generated in the method run by the
command MEAS Ref and can be used in formulas under the designation
'Command name.Variable designation':
Desig-
nation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
never been started
.DBL Total duration for the processing of the command in s
.FIN Command status; 1 = Command has ended at least
once, 0, invalid (variable not available) = Command has
never ended
.STY Type of stop with which the command was stopped: 1 =
normal; 0 = manual or after error
5.6.4.12.2 MEAS Ref - General/Hardware
Tab: Method ▶ MEAS Ref ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Input 25 characters
The general parameters for the device are defined on this tab.
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.