Metrohm tiamo 2.3 Manual - Manual (Page 1222)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1206 ￭￭￭￭￭￭￭￭ tiamo 2.3
5.6.7.2 MOVE
5.6.7.2.1 MOVE - Overview
Dialog window: Method ▶ MOVE ▶ Properties... ▶ MOVE - 'Command name'
Command for moving to a rack position (sample position or special
beaker).
Devices
This command can be executed with the following devices:
Sample Processor: 730, 774, 778, 789, 814, 815, 855, 864, 874
Appearance
The command has the following appearance:
Parameters
The parameters for the command MOVE are configured in the following
dialog window:
￭ MOVE - Properties
Command variables
The following command variables are generated in the method run by the
command MOVE and can be used in formulas under the designation
'Command name.Variable designation':
Identifi-
cation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
not ever been started
.FIN Command status; 1 = Command has been ended at
least once, 0, invalid (variable not available) = Com-
mand has never been ended
.RAN Current, absolute rotation angle of the rack in ° in relation
to the axis of the selected tower (entry when ending the
command)
.RPO Current rack position (entry at time of ending the com-
mand); 0 means 'not defined'