Metrohm tiamo 2.3 Manual - Manual (Page 1141)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 ￭￭￭￭￭￭￭￭ 1125
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
Device type
Display or selection of the device type. If a device is selected under Device
name, then this Device type field can no longer be edited, and the
device type belonging to the selected device is displayed instead.
If the option not defined is selected as Device name, any device types
or device groups which are able to execute the command can be selected,
independently of the devices in the device table.
Selection Avantes Spectrometer | 089 Photometer
Default value Avantes Spectrometer
Sensor
Colorimetric sensor
Selection of a colorimetric sensor from the table of colorimetric sensors.
The calibration data for the colorimetric sensor will be adopted for the
determination.
Selection 'Name of the colorimetric sensor' | empty or
'first list entry'
Default value empty or 'first list entry'
Temperature measurement
Type of temperature measurement.
Only displayed for Device type = 089 Photometer.
Selection continuous | off
Default value continuous
continuous
The temperature will be measured continuously.