Metrohm tiamo 2.3 Manual - Manual (Page 663)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 ￭￭￭￭￭￭￭￭ 647
Designation Description
.LP.MEA Measured value for the last measuring point of the
measuring point list in the unit of the measured value
.LP.TEM Temperature for the last measuring point of the meas-
uring point list in °C
.LP.TIM Time in s until the last measuring point in the measur-
ing point list is reached
.LP.VOL Volume for the last measuring point in the measuring
point list in mL
.MA.MEA Maximum measured value in the unit of the measured
value
.MA.TEM Temperature for the maximum measured value in °C
.MA.TIM Time in s until the maximum measured value is reached
.MA.VOL Volume at maximum measured value in mL
.MI.MEA Minimum measured value in the unit of the measured
value
.MI.TEM Temperature with minimum measured value in °C
.MI.TIM Time for the minimum measured value in s
.MI.VOL Volume at minimum measured value in mL
.MTE Temperature measurement with sensor; 1 = on, 0 =
off)
.NMP Number of measuring points in measuring point list
.SME Start measured value (measured value after processing
the start conditions) in the unit of the measured value
.STE Start temperature (temperature after processing of the
start conditions) in °C
.STY Type of stop with which the command was stopped: 1
= normal; 0 = manual or after error
.SVA Start volume absolute (volume that was added accord-
ing to the start condition "start volume") in mL
.SVM Start volume measured value (volume which was
added according to the start measured value given in
the start conditions) in mL
.SVS Start volume slope (volume that was added according
to the start condition "start slope") in mL