Metrohm tiamo 2.3 Manual - Manual (Page 1498)

7.5 856 Conductivity Module ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1482 ￭￭￭￭￭￭￭￭ tiamo 2.3
R (25 °C)
Nominal resistance of connected NTC sensor.
Only visible with temperature sensors of the NTC type.
Range
1000 ... 99999 Ohm
Default value 30000 Ohm
B value
Material constant of the NTC resistance referred to measuring the resist-
ance at 25 °C and 50 °C.
Only visible for temperature sensors of the NTC type.
Range
1000 ... 9999
Default value 4100
7.5.4 Properties - MSB #
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ MSB #
On the tabs MSB # the properties of the connector and the devices con-
nected to are displayed.
Request for dosing device preparation
Selection when the request for carrying out the command PREP (see
Chapter 5.6.6.5.1, page 1197) (prepare) is to be shown for the dosing
device connected to the MSB.
At program start
on | off (Default value: on)
If this option is switched on then at each program start the request to pre-
pare the dosing device will appear.
On attaching an exchange/dosing unit
on | off (Default value: on)
If this option is switched on then at each attaching of an exchange or dos-
ing unit the request to prepare the dosing device will appear.
Time interval
on | off (Default value: off)
If this option is switched on then the request to prepare the dosing device
will appear after the time interval defined here.