Lenze EVS9332xP User Manual
Ä.m),ä, Global drive
This manual is related to the following products:
Table of contents
Document Outline
- EDSVS9332P
- Contents
- Preface
- Safety instructions
- Technical data
- Installation of the standard device
- Wiring of the standard device
- Important notes
- Notes on project planning
- Supply forms / electrical supply conditions
- Operation on public supply systems (compliance with EN 61000-3-2)
- Controllers in the IT system
- Operation at earth-leakage circuit breaker (e.l.c.b.)
- Interaction with compensation equipment
- Discharge current for mobile systems
- Optimisation of the controller and mains load
- Reduction of noise emissions
- Mains choke/mains filter assignment
- Motor cable
- Basics for wiring according to EMC
- Standard devices in the power range 0.37 ... 11 kW
- Standard devices in the power range 15 ... 30 kW
- Standard devices with a power of 45 kW
- Standard devices in the power range 55 ... 75 kW
- Control terminals
- Wiring of the system bus (CAN)
- Wiring of the feedback system
- Wiring of digital frequency input / digital frequency output
- Commissioning
- Important notes
- Before switching on
- Switch-on sequence
- Controller inhibit
- Basic settings
- Setting the speed feedback
- Current controller adjustment
- Adjusting the rotor position
- Changing the assignment of the control terminals X5 and X6
- Manual control
- Travel profile parameters
- Parameter set management
- Homing
- Controlling the drive
- Automatic control parameter identification
- Commissioning examples
- Parameter setting
- Configuration
- Troubleshooting and fault elimination
- DC-bus operation
- Safety engineering
- Accessories (overview)
- Appendix
- Contents