Homing, Setting the homing parameters, Commissioning – Lenze EVS9332xP User Manual
Page 217
Commissioning
Homing
Setting the homing parameters
6.13
6.13.1
l
6.13−1
EDSVS9332P EN 5.0−07/2013
6.13
Homing
The reference of the motor revolution to the mechanics position gets lost
when the controller is switched off. In order to reestablish this reference, a
homing has to be carried out after switch−on.
6.13.1
Setting the homing parameters
(
Stop!
Uncontrolled, quick movements of the drive.
Incorrect settings in the configuration may cause impermissible
movements of the drive.
Possible consequences:
ƒ
The machine is damaged or destroyed.
Protective measures:
ƒ
Select low values for the acceleration and speed in manual
control in order to be able to reliably check the configuration.
ƒ
For instance use the Lenze setting. For most application cases
it is sufficient.
This manual is related to the following products: