Lenze EVS9332xP - Manual (Page 443)

Appendix
Index
13
13.2
l
13.2−5 EDSVS9332P EN 5.0−07/2013
Parameters
− entering in the program set, 6.11−4
− for homing, 6.13−1
− for manual control (inching mode), 6.10−1
− travel profile, 6.11−1
Pollution, 3.1−1
Positioning program, processing a program set, 6.11−6
Power system, 3.1−2
Process input words, 8.5−40
Process output words, 8.5−40
Program set
− entering parameters, 6.11−4
− processing, 6.11−6
Protection against unexpected start−up, 11.1−1
− operating mode, 11.2−1
− safety relay, 11.3−1
Protection of persons, 2.3−1
− with earth−leakage circuit breaker, 5.2−3
PTC motor monitoring, 6.5−12
R
Rated motor power, 8.5−6
Rated motor voltage, 8.5−7
Reaction times of digital inputs, 6.9−1
Reduce noise emissions, 5.2−6
Relay output, Configuration, 6.9−2
Residual hazards, 2.3−1
Resolver, Connecting, 5.10−2, 6.6−1
Resolver polarity check, 6.8−2
Responses, 8.2−1
− FAIL−QSP, 8.2−1
− message, 8.2−1
− TRIP, 8.2−1
− warning, 8.2−1
Rotor position adjustment, 6.8−1, 6.8−2
S
Safe standstill, 11.1−1
Safe torque off, 11.1−1
− device variant with, 5.8−5
− device variant without, 5.8−4
− functional test, 11.5−2, 11.5−5
− operating mode, 11.2−1
− safety relay, 11.3−1
Safety, safety engineering, 11−1
Safety engineering, 11−1
Safety function
− functional test, 11.5−2, 11.5−5
− Safe torque off, 11.1−1
Safety instructions, 2−1
Safety relay, 11.3−1
− Connector X11
Terminal assignment, 11.4−1
Wiring, 11.4−1
Safety relay KSR, Terminal assignment, 11.4−1
Saving, parameter set, 6.12−1
Saving of parameter set, 6.12−1
Selection of motor type, 8.5−6
Selection of the feedback system, 8.5−3
Setting of manual control (inching mode), Parameters,
6.10−1
Setting the feedback system, 6.6−1
Setting the speed feedback, 6.6−1
Site altitude, 3.1−2
Status display, keypad XT EMZ9371BC, 7.2−2
Status word, 8.5−10
− LECOM (C0150/C0155), 9.2−3
Supply conditions, 5.4−6, 5.4−7, 5.5−5, 5.5−6, 5.6−5,
5.6−6, 5.7−5, 5.7−6, 10.3−1
Supply forms, IT system, 5.2−2
Supply forms / electrical supply conditions, 5.2−1
Switch on, 6.3−1
Switch−on, check before switching on, 6.2−1
System bus (CAN), wiring, 5.9−1
System error messages, 9.3−1
− General, 9.3−1
− Resetting, 9.3−8