INFICON HAPSITE ER Chemical Identification System - Manual (Page 76)

2 - 38
IP
N 07
4-
47
1-
P1
B
HAPSITE ER Operating Manual
2.9.2 Battery Charger
The auxiliary Battery Charger (part number 930-470-G1—see Figure 2-52 )
charges up to three HAPSITE batteries in 15 hours or less. It operates using AC
power.
CAUTION
The battery charger is not sealed against moisture,
debris, or contamination.
Figure 2-52 Battery Charger
The Battery Charger operates from a range of nominal AC voltages from 100 to
230 V. It will continue to operate without internal damage at a voltage as low as
90 V and as high as 253 V. The frequency can be from 50 to 60 Hz. The Battery
Charger draws 120 W when fully loaded.
The AC power connects to the Battery Charger through a Type IEC 320 male plug,
a two-wire grounded connector rated for the full range of voltages. The connector
is recessed at the rear right-hand side of the Battery Charger and incorporates a
pair of fuses.
The Battery Charger is designed for indoor use at ambient temperatures from 5 °C
to 35 °C (41 °F to 95 °F). The Battery Charger is not designed for exposure to
contaminants because decontamination is not possible.