INFICON HAPSITE ER Chemical Identification System - Manual (Page 488)

16 - 12
IP
N 07
4-
47
1-
P1
B
HAPSITE ER Operating Manual
4 Install the green load lock cover (P/N 930-308-P1). See Figure 16-5 .
Figure 16-5 Green Load Lock Cover
5 Install the red exhaust cap (P/N 070-338). See Figure 16-6 .
6 Install the red N
2
inlet cap (P/N 070-171). See Figure 16-6 .
Figure 16-6 Red Exhaust and N2 Cap
7 Install the ethernet port cap.
8 Install the caps on the LEMO and bulkhead connector ports for the probe.
9 Install the silver LEMO plug (P/N 070-1040) on the end of the probe line.
10 Install the red probe cap (P/N 059-0382) on the probe.
11 Install the brass probe nozzle cap.
NOTE: The outside of the probe line can be decontaminated while it is still
attached to the Analytical Module. To decontaminate the inside of the
probe line, refer to
Contamination of the Probe and Probe Line, section
16.5.3 on page 16-9