INFICON HAPSITE ER Chemical Identification System - Manual (Page 159)

3 - 75
IP
N 07
4-
47
1-
P1
B
HAPSITE ER Operating Manual
3.10.2 Quick Reference SOP —
GC/MS Mode with SituProbe in Portable Mode
1 Verify that the desired sampling configuration is installed.
2 Insert the Transfer Line.
3 If the system is Shutdown or in Extended Standby, either power on the
HAPSITE or take the system out of Standby. If a Concentrator is installed, the
HAPSITE will begin preparing a Concentrator method. See
Section 3.4.3,
Procedure for Running Concentrator Methods, on page 3-25 .
3a If the SYSTEM IS NOT READY message is displayed, touch PREPARE
ANALYZE. Alternately, use the arrow keys to highlight PREPARE ANALYZE
and push OK SEL.
4 Optional: Fill vessel to the top of the outlet connection.
5 Place probe in vessel or water source.
6 Touch RUN ANALYZE or push ANALYZE RUN when the SYSTEM READY
screen is displayed.
7 Remember: when the screen prompts, Collecting Sample Now For and
Sampling is Done, no action is required from the user.
8 When the run is complete, a METHOD FINISHED prompt will appear.
9 Refer to Section 3.5.1, View Results/View Reports, on page 3-32 for
information on data review.
CAUTION
The Concentrator feature has increased sensitivity. Take
care to avoid saturating the HAPSITE.