INFICON HAPSITE ER Chemical Identification System - Manual (Page 335)

10 - 11
IP
N 07
4-
47
1-
P1
B
HAPSITE ER Operating Manual
On the Maintain Logs line of Data Settings, enter either indefinitely or the number
of days to save the files. If a number of days is selected, each time ER IQ is run,
the HAPSITE will delete the old files.
NOTE: This setting is saved in the HAPSITE ER IQ.ini file in the ER IQ program
install directory. If for any reason the HAPSITE.ini file is reloaded or
deleted, the setting will change back to the default setting of Maintain
Logs for 30 days. Log files use the naming convention:
LogYYYYMMDD.evt, where YYYY is year, MM is month, and DD is day.
10.2.3 Data Files
Data Files are automatically saved to the HAPSITE hard drive. Data Files are also
saved to the Laptop if the Laptop is connected and running ER IQ when the method
finishes. To save these files to the Laptop, use the Manage Files dialog to transfer
the files from the HAPSITE to the Laptop. For more information on transferring
files, see
section 10.3, Transferring Files Between the HAPSITE and Laptop, on
page 10-11 .
10.2.4 Tune Files
Tune files are automatically saved to the HAPSITE hard drive. To save Tune files
to the Laptop, use the Manage Files dialog to transfer the files from the HAPSITE
to the Laptop. For more information on transferring files, see
section 10.3,
Transferring Files Between the HAPSITE and Laptop, on page 10-11 .
10.2.5 Report Files
Report files are automatically saved to the HAPSITE hard drive. To save Report
files to the Laptop, use the Manage Files dialog to transfer the files from the
HAPSITE to the Laptop. For more information on transferring files, see
section
10.3, Transferring Files Between the HAPSITE and Laptop, on page 10-11 .
NOTE: Report files are embedded in the data files. Copying them to the PC is not
critical.
10.3 Transferring Files Between the HAPSITE and Laptop
Transfer of files between the HAPSITE and Laptop can be performed using the
Manage Files function in the ER IQ Laptop software. To open the Manage File
dialog, right-click on a sensor icon and select Manage Files. Alternately, select a
sensor and double-click on the Manage Files icon in the System Setup view. The
Manage Files icon is shown in
Figure 10-15 .