Spectra Precision Survey Pro CE v3.6 User Manual - Manual (Page 68)

User’s Manual
62
c. The second Stake Points screen will open
that displays all of the information
needed to locate the design point. When
connected to a total station, you would
turn the total station horizontally to
45°00’00”, vertically to 90°00’00” and
send the rod man out about 70 feet before
continuing. Tap the
6WDNH !
button to
continue to the third screen.
d. With a Height of rod of 5 , tap the
6KRW
button. (See the Reference Manual for an
explanation of the other fields.)
e. Enter the following shot data:
Angle Right : 45
Zenith: 90
Slope Dist
: 70
and then tap
2. to continue.
f. The Stake Points screen will show the
necessary COME / GO and Go RIGHT /
Go LEFT information that the rod man
must move in order to be located over the design point. In
this example, the
Go RIGHT value indicates 0 , which means
the rod is precisely on the line between the total station and
the design point. The
BACK value indicates 0.711 , which
indicates that the rod must move back (away from the total
station) 0.711 feet to be over the design point. The
Fill value is
zero so no dirt needs to be cut or filled at the rod location to
match the design elevation.
g. Assuming the rod has been repositioned, take another shot by
tapping the
6KRW
button and enter the following new shot
data:
Angle Right : 45
Zenith Angle : 90
Slope Dist : 70.8
and then tap
2. to continue.