Spectra Precision Survey Pro CE v3.6 User Manual - Manual (Page 286)

Stakeout Menu
R-129
9HUWLFDO 2IIVHW : is the offset distance that is below the design
location (when D is selected) or above the design location (when U
is selected).
*UDGH specifies a slope from the specified line to the parallel line
that is being staked. When this is a non-zero value, the elevation for
the staked points will increasingly differ from the design elevations
as the
Offset value increases.
Height of rod : is the length of the rod.
%DFNVLJKW« : accesses the Backsight Setup screen.
%DFN : returns to the previous screen.
6ROYH! : accesses the third Stake Line and Offset screen, described
next.
Note: A motorized total station will automatically turn toward the
design point after pressing
6ROYH! depending on the configuration of
the Stakeout Settings screen (Page R-33).
Stake Line and Offset – Screen Three
Station : displays the current station that is being staked.
H. Offset : displays the offset distance of the line being staked from
the specified line and if it is on the R ight or L eft
side of the specified line.
From Gun to Design Point : displays the direction
and distance that the total station must aim
toward so that it is facing the current station.
&LUFOH =HUR : is used to modify the circle on the
total station so that the angle right reading will
be zero when it is facing the current target,
which can sometimes be easier than turning to
an obscure angle value. When this button is
tapped, the following actions will occur: