Spectra Precision Survey Pro CE v3.6 User Manual - Manual (Page 201)

Survey Pro Reference Manual
R-44
Edit Polylines
-RE (GLW 3RO\OLQHV
The Edit Polylines screen is used to add, edit, and delete polylines in
the current job.
The first screen will display a list of all the
polylines that are stored in the current job.
Selecting any of the polylines listed will display a
horizontal (overhead) and vertical (side) view of
that polyline.
(GLW« : will open the selected polyline in the
New Polyline screen, described below.
'HOHWH« : will delete the selected polyline.
1HZ« : will open the Polyline Editor where a
new polyline can be created.
Screen Two – New Polyline
The second screen is used to define all of the
points that are used in the polyline. Any curve
information will be entered later, but the end
points must still be selected at this point.
The current polyline is shown on color displays
with bold red lines and all other polylines are
shown using thin black lines. Only the current
polyline data can be edited.
7DS 3RLQWV« : opens a map view where the
points in your polyline can be tapped. They must
be tapped in the order that they occur in the
polyline.
7R)URP« : Allows you to define a range of points to define a
polyline.