Spectra Precision Survey Pro CE v3.6 User Manual - Manual (Page 271)

Survey Pro Reference Manual
R-114
Stake to Line – Screen Two
The second screen is where the staking is
performed. The graphic display of this screen
will change depending on how close the rod is to
the specified line. The initial screen that is
displayed before a shot is performed shows the
position of the total station, the line of the
backsight and the specified line to stake. Each
type of graphic is displayed below.
Note: Tap the graphic portion of the screen for
an expanded view.
Height of Rod : is the length of the rod.
;
Coarse EDM (fast shot) : When checked, sets
the total station to coarse mode for faster, but
slightly less precise measurements.
BACK / FORWARD : is the distance that the rod
must travel BACK (away from the total station)
or FORWARD (toward the total station) in order
to occupy the specified line.
LEFT of Line / RIGHT of Line / ON LINE : is
displayed if the rod is to the left or right side of
the line, or is on the line. The
LEFT and RIGHT
side is determined as if occupying the Start Point and facing the
Foresight Point or Direction of the line, specified in Screen One. ON
LINE is determined if you are within the Horizontal Distance Tolerance
specified in the Stakeout Settings screen (Page R-33).
Offset Dist. : is the perpendicular offset from the specified line to the
rod. This is the minimum distance that the rod must travel to occupy
the line.
Station : is the station on the specified line where the offset occurs,
relative to the Start Point .
Initial screen before a shot is performed