Spectra Precision Survey Pro CE v3.6 User Manual - Manual (Page 289)

Survey Pro Reference Manual
R-132
Curve and Offset – Screen Two
Station to Stake : is the desired station on the
curve that you want to stake.
Station Interval : is the value that is added to the
Station to Stake after the
1H[W 6WDWLRQ button is
pressed.
1H[W 6WDWLRQ : advances the
Station to Stake by
the Station Interval .
Offset : is the horizontal distance of the offset
from the specified curve. The offset occurs on the
left (while viewing the curve from the PC) when
the
L is selected or on the right when the R is selected.
Note: An offset of zero would result in the specified curve being
staked.
9 2IIVHW : will result in the elevations for the design points to be
adjusted by the value entered here and will change the cut / fill
values accordingly. Design elevations will be lower when
D is
selected, and higher when U is selected.
*UDGH : specifies a slope from the specified curve to the curve that
is being staked. When this is a non-zero value, the elevation for the
staked points will increasingly differ from the corresponding design
elevations on the specified curve as the
Offset value increases.
Height of Rod : is the length of the rod.
%DFN : returns to the previous screen.
6ROYH! : accesses the third Stake Curve and Offset screen, described
next.
Note: A motorized total station will automatically turn toward the
design point after tapping
6ROYH! , depending on the configuration of
the Stakeout Settings screen (Page R-33).