Spectra Precision Survey Pro CE v3.6 User Manual - Manual (Page 284)

Stakeout Menu
R-127
Slope Staking Offset Stake – Screen
One
The following screens are only accessed if you choose to stake a point
at a specified offset away from the catch point.
Station : displays the current station being slope
staked.
Offset from CP : is the offset from the catch point
specified in the previous screen.
From Gun to Design Point : displays the angle
and distance information from the total station
to the design point.
&LUFOH =HUR : is used to modify the circle on the
total station so that the angle right reading will
be zero when it is facing the current target,
which can sometimes be easier than turning to an obscure angle
value. When this button is tapped, the following actions will occur:
1. A new backsight circle value is computed, sent to the
instrument and stored in the raw data
2. The Angle Right value is changed to zero to reflect the change.
The instrument now needs to be turned horizontally to zero to
face the current target location.
3. To prevent errors if this button is used, the backsight set up
is invalidated when exiting the Stakeout dialog. A circle
zeroed on a design point is meaningless once the design point
has been staked.
Note: The
&LUFOH =HUR button is not available when using a robotic
total station.
%DFN : returns to the previous screen.
6WDNH ! : accesses the next screen, which is identical to the third
Stake Points screen, described on Page R-108.