Spectra Precision Survey Pro CE v3.6 User Manual - Manual (Page 307)

Survey Pro Reference Manual
R-150
Define a Location – Screen Two
The second Define a Location screen displays the direction and
distance information from the occupy point to the new point.
Ref. Point : is the reference point specified in the
From Point field in the previous screen.
Description : is the description for the reference
point.
From Gun to Location : displays the angle and
distance information from the total station to the
new point. Users would aim their non-robotic
total station the direction specified here.
&LUFOH =HUR : is used to modify the circle on the
total station so that the angle right reading will
be zero when it is facing toward the design point,
which can sometimes be easier than turning to an obscure angle
value. When this button is tapped, the following actions will occur:
1. A new backsight circle value is computed, sent to the instrument
and stored in the raw data
2. The Angle Right value is changed to zero to reflect the change. The
instrument now needs to be turned horizontally to zero to face the
design point.
3. To prevent errors, the backsight set up is invalidated when
exiting the Stakeout dialog if this button has been used. A Circle
zeroed on a design point is meaningless once the design point has
been staked.
Note: The
&LUFOH =HUR button is not available when using a robotic
total station.
%DFN : returns to the previous screen.
6WDNH ! : accesses the third Define a Location screen where the new
point can be staked out.