Spectra Precision Survey Pro CE v3.6 User Manual - Manual (Page 26)

User’s Manual
20
Feature Code File : allows you to select a feature code file to use with
the current job. You can switch between different feature code files in
mid-job, but if a collected attribute does not match an attribute in the
feature code file, it can only be viewed, but not edited.
%URZVH : allows you to select a file to use with the current job.
Simply tap on the filename and then tap the
2SHQ button.
&OHDU : closes the currently selected file so that it is no longer used
with the current job.
Surveying Settings
The Surveying Settings allows you to select various options that
affect how data collection is performed.
;
Prompt for Description : when checked, a
prompt for a point description will appear before
any new point is stored.
;
Prompt for Height of Rod : when checked, a
prompt for the rod height will appear before any
new point is stored.
;
Survey with True Azimuths : when checked,
angle rights will be referenced from true north
when traversing.
;
Adjust for Earth Curvature / Refraction : when
checked, the elevations for new points are adjusted to compensate for
the curvature of the earth and refraction.
;
Prompt for Layer : when checked, a prompt to select a layer will
appear before any new point is stored from only the routines under
the Survey menu.
;
Prompt for Attributes : when checked, a prompt to select feature
information will appear before any new point is stored from only the
routines under the Survey menu. This also requires that a feature file
be selected from the Files Settings card, described above.