Spectra Precision Survey Pro CE v3.6 User Manual - Manual (Page 62)

User’s Manual
56
d. You can see a graphical representation of
the previous shot, as shown here, by
tapping the
Map tab. See Page 14 for
more information on the Map View.
Performing a Traverse Shot
6. The steps involved in performing a traverse shot are nearly
identical to performing a side shot. The difference is you must
specify if you plan to move the total station to the current
foresight point after the shot is taken.
a. Tap the
,QSXW tab of the Traverse / Sideshot. The Foresight
point should now be updated to 4 .
b. Assuming that you are now aiming the total station at a
prism located over the foresight point, tap
7UDYHUVH . This
would trigger the total station to take a shot, compute
coordinates for the new point and store it. Since we are
running in manual mode, we will enter the shot data from the
keypad.
c. Enter the following data:
Angle Right : 45
Zenith : 90
Slope Dist : 50
and then tap
2. .