Spectra Precision Survey Pro CE v3.6 User Manual - Manual (Page 376)

Roads Menu
R-219
Stake Road – Screen Three
The third Stake Road screen displays distance, direction, and other
information about the point to be staked.
Station : displays the station where the stake
point occurs and the type of line segment it falls
on in the alignment.
Segment : displays the name of the segment
tangent to the point to be staked; if the point is
on the
Left or Right side of the road; and the
specified offset, if any.
Angle Right : is the horizontal angle from the
backsight to the stake point.
Horz Dist : is the horizontal distance from the
total station to the stake point.
Vert Dist : is the vertical distance from the total station to the stake
point.
ZE to Rod : is the zenith angle from the total station to the stake
point.
&LUFOH =HUR : is used to modify the circle on the total station so that
the angle right reading will be zero when it is facing toward the
design point, which can sometimes be easier than turning to an
obscure angle value. When this button is tapped, the following
actions will occur:
1. A new backsight circle value is computed, sent to the instrument
and stored in the raw data
2. The Angle Right value is changed to zero to reflect the change. The
instrument now needs to be turned horizontally to zero to face the
design point.
3. To prevent errors, the backsight set up is invalidated when
exiting the Stakeout dialog if this button has been used. A Circle
zeroed on a design point is meaningless once the design point has
been staked.