Spectra Precision Survey Pro CE v3.6 User Manual - Manual (Page 32)

User’s Manual
26
General Settings
The General Settings contains the following settings:
;
Use Enter Key to Move Between Fields :
when checked, the [Enter] key will move the
cursor to the next field in all screens. When
unchecked, the [Enter] key will perform a
different function depending on the field
selected.
Note: The arrow keys and the [Tab] key can
also be used to move the cursor between fields.
;
Allow Alphanumeric Point Names : when
checked alphanumeric point names can be assigned to any point.
When unchecked, all point names must be numeric.
;
Always Prompt for Backsight Check : when checked, you will be
prompted if you attempt to exit the Backsight Setup screen without
first performing a backsight check.
;
Beep When Storing Points : when checked, a beep will sound
whenever a new point is stored.
;
Prompt for Description : when checked, a prompt for a description
will appear before any new point is stored from any routine other
than those included in the Survey and Stakeout menus.
;
Prompt for Layer : when checked, a prompt to select a layer will
appear before any new point is stored from any routine other than
those included in the Survey and Stakeout menus.
;
Prompt for Attributes : when checked, a prompt to select feature
information will appear before any new point is stored from any
routine other than those included in the Survey and Stakeout menus.
This also requires that a feature file be selected from the Files
Settings card, described earlier.
;
Prompt to Backup When Closing Job : when checked, a reminder
will open to backup the current job prior to closing it.