Spectra Precision Survey Pro CE v3.6 User Manual - Manual (Page 375)

Survey Pro Reference Manual
R-218
Station Interval : is the value that is added to the
Station to Stake after the
1H[W 6WDWLRQ button is
pressed.
1H[W 6WDWLRQ : advances the
Station to Stake by
the Station Interval .
Note: If the Stake Corners option is selected in
the Stakeout Settings screen, the
1H[W 6WDWLRQ
button will also stop at any horizontal or vertical
alignment node, and the beginning and end of
any widening and super elevation that falls within the interval.
, !! : These buttons are used to select the particular node, or
an offset to it, from your road profile that you wish to stake. The
segment name at the selected node is also displayed. If staking the
centerline with an offset, the side of the road that the offset occurs is
also displayed.
Offset from the segment above : When checked, allows you to specify
an offset distance to stake as opposed to staking the actual node
locations.
Note: A positive value offset is applied at the specified distance from
each node away from the centerline. A negative value offset is
applied at the specified distance from each node toward the
centerline.
Note: If an offset occurs past the edge of the road, no vertical or cut /
fill information will be computed for that point.
%DFNVLJKW« : accesses the Backsight Setup screen (Page R-72).
%DFN : returns to the previous screen.
1H[W ! : takes you to the next Stake Road screen where the direction
and distance information to the stake point is displayed.