Spectra Precision Survey Pro CE v3.6 User Manual - Manual (Page 133)

Screen Examples
127
Editing Boundary Data
Any entered section can be modified if an error is discovered. To edit
a particular section, select the section from the left-hand portion of
the screen and tap the
(GLW« button. The details of the selected
section will open in the same editor that was used to create it. Simply
make the necessary changes and tap
2..
Adding Boundary Data to the Current
Project
You can add the boundary data that was entered to your current
project. Points will then be created for the ends of each section that
was entered and the line for the boundary is stored as a polyline.
The polyline can be used in any routine that supports them such as
Inverse Point to Polyline, Edit Lines, Computer Area, etc.
1. To add the boundary data to the current project, tap the
$GG WR PDS« button.
2. In the Description field, enter the desired name for the polyline
that will be stored.
3. Define the location of the beginning of the first section that
defines your boundary.
• To specify a new location, tap the 8VH /RFDWLRQ! button and
enter the appropriate northing, easting and elevation.
• To specify an existing location, tap the 8VH 3RLQW! button, and
enter the point name in the same field. (Alternatively, you
can tap the
button and then tap on a point from the map
view.)
4. Enter a name for the initial stored point in the Store points field.
Each new point that follows will automatically be stored with the
next available consecutive point name.