KORG Electronic Keyboard - Manual (Page 886)

Effect Guide
876
140: Reverb - Gate
This effect combines a mono reverb and a gate.
REVERB
Pre EQ
Trim [0…100]
Sets the EQ input level.
LEQ Fc [Low, Mid-Low]
Selects the cutoff frequency (low or mid-low) of the
low-range equalizer.
LEQ Gain [dB] [–15.0…+15.0]
Sets the gain of the Low EQ.
HEQ Fc [High, Mid-High]
Selects the cutoff frequency (high or mid-high) of the
high-range equalizer.
HEQ Gain [dB] [–15.0…+15.0]
Sets the gain of the High EQ.
REVERB
Pre Delay [msec] [0…200]
Sets the delay time of the reverb sound and gate
control signal.
High Damp [%] [0…100]
Sets the damping amount in the high range.
Reverb Time [sec] [0.1…10.0]
Sets the reverberation time.
Wet/Dry [Dry, 1:99…99:1, Wet]
Sets the reverb effect balance.
GATE
CONTROL
Envelope Select [Dmod, Input]
This chooses whether the gate is triggered by the signal
level, or controlled directly by the selected Dmod
Source.
When Envelope Select is set to Input, the gate is
controlled by a blend of the dry audio input and the
reverb output, as set by the Input Reverb Mix.
Source [Off…Tempo]
Selects the modulation source that controls the gate
when Envelope Select is set to Dmod.
Input Reverb Mix [Dry, 1:99…99:1, Wet]
This mixes the dry input and reverb output signals, for
controlling the gate.
Normally, set Input Reverb Mix to Dry, so that the
gate is controlled only by the dry input. If you wish to
extend the gate time, increase the Input Reverb Mix
value to include some of the wet mix as well, and
adjust the Threshold.
GATE
Threshold [0…100]
Sets the gate threshold level. When the signal level
exceeds the threshold, the gate opens and the reverb
sound is heard.
Note that this applies only when Envelope Select is set
to Input. When the gate is controlled via Dmod, it
opens when the Dmod value is 64 or higher, and closes
when the value is 63 or lower.
Attack [1…100]
Sets the attack time. p.772.
Release [1…100]
Sets the release time. p.772.
Polarity [+, –]
This lets you invert the gate on/off state. p.772.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see “OUTPUT” on page 764.
Left
Right
Wet / Dry
Wet / Dry
Reverb
Balance
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
+
LEQ HEQ
EQ Trim
Reverb Pre Delay
Envelope - Control
D-mod
Input
Envelope Select
Gate
Input Reverb Mix
Reverb
Gate
Gate+Dmpr