KORG Electronic Keyboard - Manual (Page 632)

Sampling mode
622
2) Press the OK button to execute Auto Sampling
Setup (Auto Resample through IFX), or press the
Cancel button if you decide not to execute. For more
information, please see “Auto Sampling Setup:
Automatically-set parameters and their values” on
page 622.
Note: When you are ready to resample (after executing
Auto Resample through IFX), perform the following
steps.
1) Use Key (0–8c) to specify the key to which the
sample you want to resample is assigned.
2) Use P8: Insert Effect to make effect settings. To
hear the sound, play the note you specified in Key.
3) To begin resampling, press the SAMPLING REC
key and then the SAMPLING START/STOP switch.
(This is because Trigger is set to Sampling START
SW.) The sample will play, and when playback ends,
it will be resampled.
Note: To check the resampled data, play the note you
specified in the Key parameter.
To prevent the insert effect from being applied “in
duplicate” when you listen to the resampled data,
“Bus Select All OSCs to” (8–1b) will automatically
be set to L/R when resampling ends. If you want to
apply IFX and resample once again, you will need
to change this setting back to the same IFX.
Auto Sampling Setup: Automatically-set parameters and their values
–: Not set automatically
[ ]: Set automatically according to the parameter
settings in the dialog box
*1Edit sampling mode parameters
*2Uses the input source specified as Source Audio.
*3:If IFX is Off this will be L/R. If IFX1…12 is
selected this will be IFX1…12.
*4L-Mono if the Source Audio is Mono-L, R-Mono if
it is Mono-R, and Stereo if it is Stereo
*5When Save to=RAM
*6Specify the BUS Select of that IFX1…12. If effects
are chained, specify the last IFX in the chain.
[Initialize] [REC Audio Input] [Auto Resampling through IFX]
Input (Input Source) *1
Input1, 2, 3, 4
S/P DIF
[Source Audio] *2
Input1, 2, 3, 4
S/P DIF
Input1, 3, S/P DIF-L
Bus Select Off [IFX] *3 Off
FX Ctrl Bus Off Off Off
REC Bus Off Off Off
Send1/2 000 000 000
Pan L000 L000 L000
Level 127 127 127
Input2, 4, S/P DIF-R
Bus Select Off [IFX] *3 Off
FX Ctrl Bus Off Off Off
REC Bus Off Off Off
Send1/2 000 000 000
Pan R127 R127 R127
Level 127 127 127
Sampling Setup
(Name)
Source Bus L/R L/R L/R
Source Direct Solo (N/A) (N/A) (N/A)
Trigger Sampling START SW Sampling START SW Sampling START SW
Metronome Precount (N/A) (N/A) (N/A)
Pre Trigger REC – – –
Resample Manual Manual Auto
REC Sample Setup
Save to RAM [Save to] RAM
Mode Stereo [Source Audio] *4 Stereo
Rec Level +0.0 +0.0 +0.0
Auto +12dB On On On *5 On
Auto Loop On On – –
Select Directly – – – –
Routing
Bus Select (All OSCs to) L/R – [IFX]
FX Crtl Bus Off – Off
REC Bus Off – Off
Send1/2 127 – 000
Insert FX Bus Select (Post IFX) – L/R *6 L/R *6