KORG Electronic Keyboard - Manual (Page 817)

Chorus, Flanger, and Phaser 053: Stereo Envelope Phaser
807
Amount [+/–100]
Sets the modulation amount for Wet/Dry.
053: Stereo Envelope Phaser
This stereo phaser uses an envelope generator for
modulation. You will obtain the same pattern of
phasing each time you play. You can also control the
Phaser directly using the modulation source.
PHASER
L Manual Bottom [0…100]
Sets the lower limit of the left-channel phaser’s sweep.
For more information on the Bottom and Top settings,
see the graphic under “Frequency Bottom” on
page 777.
L Manual Top [0…100]
Sets the upper limit of the left-channel phaser’s sweep.
R Manual Bottom [0…100]
Sets the lower limit of the right-channel phaser’s
sweep.
R Manual Top [0…100]
Sets the upper limit of the right-channel phaser’s
sweep.
CONTROL
Sweep Mode [EG, Dmod]
Determines whether the phaser is controlled by the
envelope generator or by the modulation source. p.804.
Source [Off…Tempo]
Selects the modulation source that triggers the EG
(when EG is selected for Sweep Mode), or modulation
source that causes the phaser to sweep (when Dmod is
selected for Sweep Mode). p.804.
EG
Attack [1…100]
Sets the EG attack time. For more information Attack
and Release, see the graphic under “Attack [msec]” on
page 766.
Decay [1…100]
Sets the EG decay time.
PHASER
Resonance [+/–100]
This controls the intensity of the phaser. For more
information, see “Resonance” on page 805.
High Damp [%] [0…100]
This sets the amount of high-frequency damping in the
phaser’s feedback loop. Increasing the value will cut
high-range harmonics.
OUTPUT
Wet/Dry [–Wet…–1:99, Dry, 1: 99…Wet]
Sets the balance between the “wet” processed sound
and the dry input. Negative values invert the phase of
the wet signal. This interacts with Resonance; for more
information, see “Resonance” on page 805.
Source [Off…Tempo]
Selects a modulation source for Wet/Dry.
Amount [+/–100]
Sets the modulation amount for Wet/Dry.
054: Bi Phaser
This effect provides two independent phasers that can
be connected in series or in parallel.
PHASER1
Manual [0…100]
Sets the frequency of phaser 1.
LFO1 Depth [0…100]
Sets the LFO modulation depth of phaser 1
Source [Off…Tempo]
Selects a source to control LFO modulation depth of
both phasers.
EG Attack/Decay
EG
D-mod
Sweep Mode
D -mod
Phaser
Phaser
Left
Right
Resonance
Wet / Dry
Wet / Dry
High Damp
Stereo In - Stereo Out
Wet: Mono In - Stereo Out / Dry: Stereo In -Stereo Out
Left
Right
Wet / Dry
Wet / Dry
Phaser
Phaser
Phase Lock
+
Mode
Serial
Dual
Resonance
Output Level1
Output Level2
Resonance
+
LFO2
LFO1 Output Mode