KORG Electronic Keyboard - Manual (Page 754)

Effect Guide
744
Mixer
In Program, Combination, and Sequencer modes, the
P8 - Insert FX page lets you set “Pan (CC#8)” (post-IFX
panning), “Bus Sel. (Bus Select),” “Ctrl Bus” (FX
control bus), REC Bus, and Send1 and Send2 levels to
the master effects.
If you have checked the Chain to connect the Insert
Effects in series, these parameters “Pan (CC#8)” –
Send2 for the post-IFX (last Insert Effect in the chain)
signal become effective.
Pan (CC#8)
This parameter enables you to set the pan of the post-
IFX signal.
If you are using the stereo-in/stereo-out Insert Effects,
set this parameter to “C064” to enable the Pan settings
for the oscillators (Program 4–1c, 4–5), timbres
(Combination 0–1b), tracks, and audio inputs.
If you are using mono-in/stereo–out or mono-
in/mono–out Insert Effects, the Pan settings for the
oscillators, timbres, tracks and audio inputs are
ignored, and they are set to Center. Use the “Pan
(CC#8)” parameter (P8: “Insert FX” page) to set the
pan. “L000” is hard left, and “R127” is hard right.
For more about effect types such as stereo-in/stereo-
out, see “In/Out” on page 734.
You can control these parameters via CC#8.
Bus Sel. (Bus Select)
This parameter enables you to specify the destination
bus for the post-IFX signals.
“L/R” is a common setting to send signals to the Total
Effects (TFX1, TFX2) before they are routed to the
OUTPUT (MAIN) L/MONO and R outputs.
Select 1…8 or 1/2…7/8 to route the signals to
OUTPUT (INDIVIDUAL) 1–8 (“Individual Outputs”).
If this is set to 1–8, the output will be monaural. If set to
1/2–7/8, the post-IFX pan settings will be valid, and the
output will be stereo. If set to Off, the signal will not be
sent to the L/R bus or buses 1–8. Choose this setting if
OSC1: Amp1 Pan=L001
OSC2: Amp2 Pan=R127
Left Center Right
Post IFX Pan(CC#8)
C064
Left Center Right
L032
L001
R096
R127
Insert Effect = Stereo In - Stereo Out
Left Center Right
Left Center Right
OSC1 OSC2
OSC1: Amp1 Pan=L032
OSC2: Amp2 Pan=R096
Post IFX Pan(CC#8)
C064
L032
L001
R096
R127
OSC1: Amp1 Pan=L001
OSC2: Amp2 Pan=R127
Left Center Right
Post IFX Pan(CC#8)
C064
Left Center Right
L032
L001
R096
R127
Insert Effect = Mono In - Stereo Out
OSC1 OSC2
Mono In - Mono Out