KORG Electronic Keyboard - Manual (Page 833)

Modulation and Pitch Shift 072: Pitch Shift Mod.
823
INPUT
Input Level Dmod [%] [+/–100]
Sets the modulation amount of the input level. p.820.
Source [Off…Tempo]
Selects the modulation source for the input level. p.820.
PITCH SHIFTER
Mode [Slow, Medium, Fast]
Switches Pitch Shifter mode. p.821.
L/R Pitch [Normal, Up/Down]
Determines whether or not the L/R pitch shift amount
is inverted. p.821.
Pitch Shift [1/2 steps] [–24…+24]
Sets the pitch shift amount in steps of a semitone. p.821
Fine [cents] [+/–100]
Sets the pitch shift amount in steps of one cent. p.821
Source [Off…Tempo]
Selects the modulation source of pitch shift amount.
p.821.
Pitch Shift Amount [–24…+24]
Sets the modulation amount of pitch shift amount.
p.821.
Fine Amount [+/–100]
Sets the modulation amount of pitch shift amount Sets
the modulation amount of pitch shift amount. p.821.
DELAY
BPM [MIDI, 40.00…240.00]
MIDI syncs to the system tempo; 40-240 sets the tempo
manually for this individual effect. p.822.
Time Over? L > [---, OVER!]
Display the error message if the left channel delay time
exceeds the upper limit. p.822.
Time Over? R > [---, OVER!]
Display the error message if the right channel delay
time exceeds the upper limit. p.822.
L Base Note [ …
Selects the type of notes to specify the left channel
delay time. p.822.
Times [x1…x32]
Sets the number of notes to specify the left channel
delay time. p.822.
R Base Note [ …
Selects the type of notes to specify the right channel
delay time. p.822.
Times [x1…x32]
Sets the number of notes to specify the right channel
delay time. p.822.
Feedback Position [Pre, Post]
Switches the feedback connection. p.821.
Feedback [+/–100]
Sets the feedback amount. p.821.
High Damp [%] [0…100]
Sets the damping amount in the high range.
Spread [+/–100]
Sets the width of the stereo image of the effect sound.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see “OUTPUT” on page 764.
072: Pitch Shift Mod.
This effect uses an LFO to modulate the pitch shift
amount, and lets you adjust the panning and stereo
width between the effected and dry sounds.
PITCH SHIFTER
Pitch Shift [cents] [+/–100]
Sets the pitch difference from the input signal.
Depth [+/–100]
Sets the LFO modulation depth for pitch shift amount.
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
LFO: Tri / Sqr
Pan
+ Pitch Shifter
Pitch
Higher
Pitch Shift Mod - Pitch Shift / Depth
Lower
Original Pitch
Pitch Shift (+ value)
LFO Waveform=Triangle
Depth (+value)
LFO Waveform=Square
Depth (—value)