KORG Electronic Keyboard - Manual (Page 359)

Combination P1: EQ/Vector/Controller 1–5: Vector Volume Control
349
Vector Synthesis system, Combi mode
1–5b: Vector Volume Control
Vector Volume Control lets you adjust the relative
volumes of the 16 Timbres by moving the Vector
Joystick (or the Vector Envelope) from left to right on
the X axis, and up and down on the Y axis.
The Equal Amount check-box makes the Vector create
a smooth fade between the Timbres, while the
individual Timbre Center Volume parameters allow
you to create more complex fade shapes.
Enable Volume Control [Off, On]
When this box is checked, the Vector position will
control the volumes of all Timbres whose VJS Assign
parameter is not set to Off.
When this box is not checked, the Vector position will
not directly affect volume. However, it’s still possible
for the Vector to control volume via Vector CCs and
AMS, depending on the individual Program’s
parameter settings.
Combi Vector CC Control
Vector Joystick
Combi
Vector EG
VJS X and Y modes
Combi switch:
Enable CC control
X+/- and Y+/-
CC Assignments
Vector CC Modulation of
Program and FX Parameters
(Global Channel Only)
Combi Vector Volume Control
Combi switch:
Enable Volume control
Vector Modulation of
Timbre Volume
Timbres 1-16 Center Volume
and Equal Power settings
Vector Joystick
MIDI In
(Global Chan.)
Vector CC MIDI Output
Combination
Global switch:
Vector MIDI Out
Vector Joystick
Vector CC Control
Vector CC MIDI Output Global Controllers
MIDI CC Assignments
Defaults: X=118, Y=119
Program
Vector EG
Vector Joystick
MIDI In
(Timbre Chan.)
Timbre 1
Timbre 16
The front-panel Vector Joystick applies only
when the Timbre is set to the Global Channel
+
+
Program switch:
Enable Volume control
Vector Modulation of
Osc 1-2 Volume
Osc 1-2 Center Volume
and Equal Power settings
Program Vector Volume Control
VJS X and Y modes
Program switch:
Enable CC control
X+/- and Y+/-
CC Assignments
Vector CC Modulation of
Program Parameters
Program Vector CC Control