KORG Electronic Keyboard - Manual (Page 812)

Effect Guide
802
LFO2 Amount [–20.00…+20.00]
This sets the LFO2 Frequency modulation amount, in
Hz.
MIDI/Tempo Sync [Check-box]
BPM [MIDI, 40.00…240.00]
LFO1 Note [ … ]
Times [x1…x32]
LFO2 Note [ … ]
Times [x1…x32]
When MIDI/Tempo Sync is on, the LFO speeds are set
by BPM, Note, and Times, instead of Frequency. The
two LFOs each have their own settings for Note and
Times. For more information, see “MIDI/Tempo Sync”
on page 777.
MODE
Chorus 1 and 2 are connected as shown in the diagram.
Routing [Dual, Serial]
Selects parallel or serial connection for chorus 1 and 2.
If Routing is set to Serial, the Chorus 1 Output Level,
Chorus 2 Output Level, and Chorus 2 Feedback
settings are ignored.
Output Mode [Mono, Stereo]
This applies only when Routing is set to Dual.
Mono: The outputs of both chorus 1 and 2 are summed
together and panned to the center.
Stereo: Chorus 1 goes to the left output, and chorus 2
goes to the right output.
Chorus1 Output Level [0…100]
Sets the output level for chorus 1.
Chorus2 Output Level [0…100]
Sets the output level for chorus 2.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see “OUTPUT” on page 764.
046: Ensemble
This Ensemble effect has three chorus blocks that use
LFO to create subtle shimmering, and gives three
dimensional depth and spread to the sound, because
the signal is output from the left, right, and center.
ENSEMBLE
Depth [0…100]
Sets the depth of the LFO modulation.
Source [Off…Tempo]
Selects the modulation source for the LFO depth.
Amount [+/–100]
Sets the modulation amount of the LFO modulation
depth.
LFO
Speed [1…100]
Sets the LFO speed.
Source [Off…Tempo]
Selects a modulation source for LFO speed.
Amount [+/–100]
Sets the modulation amount of LFO speed.
Shimmer [0…100]
This parameter sets the amount of shimmering of the
LFO waveform. Increasing this value adds more
shimmering, making the chorus effect more complex
and richer.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see “OUTPUT” on page 764.
Routing: Dual
Output Mode: Mono
Routing / Output Mode / Output Level 1/2
Routing: Dual
Output Mode: Stereo
Output Level1/2 Output Level1/2
Routing: Serial
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
LFO
Shimmer
+ Ensemble
Time
Level
Ensemble LFO
Shimmer