Sliders 1–8 and master slider, 0–9: page menu commands – KORG Electronic Keyboard User Manual

Page 459

Sequencer P0: Play/REC 0–9: Control Surface

449

On Value

[Depends on parameter]

The parameter is set to this value when the switch is
On.

When the switch is assigned to a two-state Absolute
parameter, such as Hold, this will always be the same
as the Switch Status (see below).

Switch Status

[Off, On]

This simply shows whether the switch is On or Off.
The status is also shown by the LEDs in the physical
buttons.

Sliders 1–8 and Master Slider

These work identically to Knobs 1–8, as described
above.

▼ 0–9: Page Menu Commands

The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.

• 0: Memory Status. For more information, see

• 1: Exclusive Solo. For more information, see

• 2: Rename Song. For more information, see

• 4: Copy From Song. For more information, see

• 5: Load Template Song. For more information, see

• 6: Save Template Song. For more information, see

• 7: FF/REW Speed. For more information, see

• 8: Set Location (for Locate Key.) For more

• 10: Copy From Combination. For more

• 11: Copy From Program. For more information, see

• 12: Copy Tone Adjust. This is available only when

Control Assign is set to TONE ADJUST. For more
information, see “Copy Tone Adjust” on page 407.

• 13: Reset Tone Adjust. This is available only when

Control Assign is set to TONE ADJUST. For more
information, see “Reset Tone Adjust” on page 407.

• 12: Copy Scene. This is available only when

Control Assign is set to RT KNOBS/KARMA. For
more information, see “Copy Scene” on page 147.

• 13: Swap Scene. This is available only when

Control Assign is set to RT KNOBS/KARMA. For
more information, see “Swap Scene” on page 147.