KORG Electronic Keyboard - Manual (Page 570)

Sequencer mode
560
System Exclusive events supported in Sequencer mode
You can record and play back System Exclusive events,
and edit tracks that contain System Exclusive events.
SysEx messages that can be recorded in real-time
The following exclusive messages can be recorded in
real-time:
• Exclusive messages received from an external MIDI
device
• Parameter changes in Sequencer mode (see table
below)
• Master Volume universal exclusive messages
assigned to the foot pedal or a knob
Parameter change messages that you can realtime-record in Sequencer mode
*1:Solo On/Off is always controlled by events in the
track, regardless of the play/mute status of that
track.
The maximum amount of exclusive data that can be
recorded at once is approximately 320 Kbytes. This
size will decrease if other events exist within the
same measure.
You cannot simultaneously record exclusive
messages received from an external MIDI device
and parameter changes produced by editing.
If you record a parameter assigned to a control
change such as Pan with the Global mode Global
P1: MIDI, MIDI Filter settings “Enable Control
Change” and “Enable Exclusive” both checked,
edits you make during recording will be recorded
both as control change data and parameter change
Front panel/Page Parameter
Front panel
KARMA ON/OFF, LATCH, MODULE CONTROL switches
Control Surface CONTROL ASSIGN, MIXER KNOBS, PAD MODE switches
P0: Play/REC
MIDI Prog Mixer Program Select, Pan, Volume, PLAY/MUTE, Solo On/Off *1
Audio Track Mixer Rec Source, Pan, Volume, PLAY/MUTE, Solo On/Off *1
Audio In Sampling All “Audio Input” parameters
Control Surface
All “RT/KARMA” – “REAL TIME CONTROL,” “KARMA SCENE,” “KARMA SWITCH,”
“KARMA SLIDER” parameters, “TONE ADJ.” – Assign, Value
P1: EQ/Vector
Control
MIDI Track EQ
Auto Load Prog EQ, Bypass, Input Trim, High Gain, Mid Frequency, Mid Gain, Low
Gain
Audio Track EQ Bypass, Input Trim, High Gain, Mid Frequency, Mid Gain, Low Gain
Vector Volume
All “Vector Volume Control” parameters, VJS Assign, Center Volume, Enable Program
Vector Volume
Vector CC
All “Vector CC Control” parameters, Enable Song Vector CC, Enable Program Vector
CC
Vector Envelope All “Basic,” “Vector Envelope Loop,” “Vector Envelope” parameters
Set Up Controllers All “Panel Switch Assign,” “Modulation Knob Assign” parameters
Set Up Pads All “Pads Chord” parameters
P2: Track Param
MIDI Track Priority
OSC Force OSC Mode, OSC Select, Portamento
Pitch Transpose, Detune, Bend Range, Use Program’s Scale, Type, Key, Random
Delay Mode, Time, Base Note, Times
WaveSeq KARMA Key Sync, Swing, Quantize Trigger, KARMA Track On/Off Control
Audio Track Delay Mode, Time, Base Note, Times
P7: KARMA
GE Setup Key Zones Load GE Options
Name Note Map All parameters except “Octave Replicate”
P8: IFX
MIDI/Audio Routing1/2 “Bus Select, Send1, Send2, Fx Control Bus, Rec Bus
Insert FX IFX, IFX On/Off, Chain to, Chain, Pan, Bus Sel, REC Bus, Ctrl Bus, Send1, Send2
IFX 1-12 All effect parameters
Common FX LFO All “Common FX LFO 1, 2” parameters
P9: MFX/TFX
Routing
MFX, MFX On/Off, Chain, Chain Direction, Chain Level, Return 1, Return 2, TFX, TFX
On/Off, Master Volume
MFX 1/2 All effect parameters
TFX 1/2 All effect parameters