KORG Electronic Keyboard - Manual (Page 697)

Global: Page Menu Commands Reset External Setup
687
Trigger KARMA generation from external
device/sequencer
Choose this if you want the KARMA Module to be
triggered by MIDI input from an external MIDI
device or MIDI sequencer.
You can also select this if you want only the
OASYS’s keyboard performance that triggers the
KARMA Module to be sent as MIDI output and
recorded on an external sequencer, and then use the
echo-back or playback from the external sequencer
etc. to trigger the KARMA Module.
Both (note: possibility of MIDI feedback loop)
Choose this if you want to make both of the above
settings.
Be aware that in some cases, the phrases generated
by the KARMA Module will pass through the
external MIDI device (MIDI sequencer) and re-
trigger the KARMA Module – producing a MIDI
feedback loop that may cause undesired operation.
You will need to manage the MIDI signal routing to
ensure that MIDI feedback does not occur, for
example by disabling MIDI IN→OUT echo-back in
your MIDI sequencer.
3. Press the OK button to execute the Setup KARMA
External MIDI Routing command, or press the
Cancel button to cancel.
Reset External Setup
This command initializes the external controller
settings.
All settings for Knob 1–8, Switch 1–16, Slider 1–8,
Master Slider, and Pad 1–8 will be initialized for the
selected setup number.
“Channel” = Gch
“Assign” = Off
Pad Only “Velocity” = 127
1. Select the setup number that you want to reset.
2. Choose Reset External Setup to open the dialog
box.
3. Press the OK button to execute Reset External
Setup, or press the Cancel button to cancel.
Reset Controller MIDI Assign
This command resets the MIDI control change (CC)
assignments for the KARMA Sliders and Switches, the
8 pads, and the Vector Joystick. You can use this
command to restore the standard settings, and then
adjust any or all of the assignments manually, if you
like.
For more information on these settings, see “2–1:
Controller” on page 659.
1. Choose “Reset Controller MIDI Assign” to open
the dialog box.
2. Set the “To” field to the desired reset method.
All Off: All settings will be Off.
Default Setting: The KARMA controls and pads
will all be set to Off; the Vector Joystick will be set to
its default CCs.
MIDI IN
MIDI IN
MIDI OUT
MIDI OUT
Local
control OFF
ON
Tone
Generator
KARMA
MIDI Sequencer
(Echo back Off)
Recording
Enable
KARMA Module
to MIDI Out
Enable MIDI In
to KARMA Module
MIDI IN
MIDI IN
MIDI OUT
MIDI OUT
Local
control OFF
ON
Tone
Generator
KARMA
MIDI Sequencer
Playback
Enable
KARMA Module
to MIDI Out
Enable MIDI In
to KARMA Module
MIDI IN
MIDI IN
MIDI OUT
MIDI OUT
Local
control
OFF
ON
Tone
Generator
KARMA
MIDI Sequencer
(Echo back On)
Recording
Enable
KARMA Module
to MIDI Out
Enable MIDI In
to KARMA Module
MIDI IN
MIDI IN
MIDI OUT
MIDI OUT
Local
control OFF
ON
Tone
Generator
KARMA
MIDI Sequencer
Playback
Enable
KARMA Module
to MIDI Out
Enable MIDI In
to KARMA Module