KORG Electronic Keyboard - Manual (Page 806)

Effect Guide
796
MIC SIMULATOR
Type [Vnt.Dy/55SH, Mlt.Cn/C414, Pc.Cn/C451,
Whale/MD421, Vo.Dy/SM58, Mlt.Dy/SM57,
Vo.Cn/U87, Vo.Tube/U47, BDr.Dy/RE20]
Selects the type of mic.
Position [Close, On, Off, Far]
This expresses the effect that the mic position has on
the sound. The Close setting is the closest mic position,
and the Far setting is the farthest.
TUBE PREAMP
Low Cut [Hz] [Thru, 21…8.00k]
Sets the frequency of the low cut filter.
High Cut [Hz] [53…20.00k, Thru]
Sets the frequency of the high cut filter.
Gain [dB] [–24.0…+24.0]
Sets the input gain to the vacuum tube preamp.
Saturation [%] [0…100]
Sets the input/output response of the preamp.
At higher settings, the waveform will change at high
gain levels, tending to cause distortion. Lower settings
will produce linear response.
Bias [0…100]
This expresses the effect that changes in vacuum tube
bias have on the distortion of the waveform. Higher
settings of this value will produce distortion even at
low gain levels. Since this will also change the
overtone structure, you can use it to control the tonal
character.
Output Level [dB] [–48.0…+0.0]
Sets the output level of the preamp.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see “OUTPUT” on page 764.
039: St. Mic Modeling +PreAmp
This similar to “038: Mic Modeling +PreAmp”, but in
stereo. For example, you might use this to simulate
micing of a stereo source such as a rotary speaker.
For more information, see “038: Mic Modeling
+PreAmp” on page 795.
Mic/Pre Amp - Saturation
In
Out
Saturation = 0
Saturation = 50
Saturation = 100
Bias = 0
In
Out
Satulation = 50
Bias = 0
Bias = 50
Bias = 100
Mic/Pre Amp - Bias
Tube Pre Amp Mic Simulation
Tube Pre Amp Mic Simulation
Left
Right
Wet / Dry
Output Level
Wet / Dry
Stereo In - Stereo Out