Wavetronix Click 400 (900 MHz radio) (CLK-400) - User Guide - Manual (Page 89)

88 CHAPTER 9 • CLICK 110
Note
This parameter can also be changed using the front panel menu or Click Supervisor.
The switch patterns for the two parameters are identical, but bus 1 is configured using
switches 1–4 (S1:1–4) while bus 2 is configured using switches 5–8 (S1:5–8).
S1: Bus 1 Baud Rate
1 2 3 4 Value
Off – – – Software mode
On Off Off Off 9600 bps
On Off Off On 19200 bps
On Off On Off 38400 bps
On Off On On 57600 bps
On On Off Off 9600 bps
On On Off On 9600 bps
On On On Off 9600 bps
On On On On 9600 bps
S2: Bus 2 Baud Rate
5 6 7 8 Value
Off – – – Software mode
On Off Off Off 9600 bps
On Off Off On 19200 bps
On Off On Off 38400 bps
On Off On On 57600 bps
On On Off Off 9600 bps
On On Off On 9600 bps
On On On Off 9600 bps
On On On On 9600 bps
Table 9.2 – DIP Switch Baud Rate Settings for Bus 1 (left) and Bus 2 (right)
As these tables show, if the switches are in any configuration besides the ones laid out in the
first few rows of these tables, that bus will default to 9600 bps.
If switch 1/5 is on (up), Hardware mode is selected, meaning the baud rate can be config-
ured using the DIP switches (as shown in Table 9.2 above), and Click Supervisor and the
front panel menu will be able to display the current setting, but not change it. (Dashes in the
table above indicate that the other three switches don’t affect Software mode selection.) If
switch 1/5 is off (down), Software mode is selected and Click Supervisor and the front panel
menu will be able to both display and change the current setting.
Channel Enable
The next parameter that can be configured is which of the output channels are enabled.
Enabling output channels is located on the second DIP switch, labeled S2, and is controlled
with switches 4–8 (S2:4–8).
Note
This can also be changed using the front panel menu or Click Supervisor.