Wavetronix Click 400 (900 MHz radio) (CLK-400) - User Guide User Manual
Page 217
216
CHAPTER 24 • CLICK 304
Figure 24.9 – Expert Driver Autobaud Tab
Setting
Description
Command
Allows you to set the command sent from the device during the
autobaud process. Don’t change these values unless instructed to by
Wavetronix Technical Services.
Response
Shows the response the device is expecting from the above com-
mand. Don’t change these values unless instructed to by Wavetronix
Technical Services.
SmartSensor ID
Shows the ID number of the sensor with which the Click device is
currently communicating. This only shows the number after you have
autobauded the Click device; when the Click device is not communi-
cating with a sensor, this option will display a 0.
Server/Client
Allows you to set whether the device is a server or client in a point to
multipoint setup. (This option is not related to device autobauding.)
Table 24.6 – Expert Driver Autobaud Tab
Under the Diagnostics tab, you can run diagnostics on your device (see Figure 24.10).
Click the General button to run diagnostics on the items listed below the button. If a prob-
lem is detected, the program will display a red square next to the item in question. If no
problems are detected, a green circle will appear.
- Click 421 (bluetooth to serial converter) (CLK-421) - User Guide Click 342 (lean managed ethernet switch) (CLK-342) - User Guide Click 341 (lean managed ethernet switch) (CLK-341) - User Guide Click 340 (lean managed ethernet switch) (CLK-340) - User Guide Click 331 (unmanaged ethernet switch) (CLK-331) - User Guide Click 330 (unmanaged ethernet switch) (CLK-330) - User Guide Click 304 (RS-232 to RS-485 converter) (CLK-304) - User Guide Click 305 (RS-232 to RS-485 converter) (CLK-305) - User Guide Click 301 (serial to ethernet converter) (CLK-301) - User Guide Click 100 (16 output contact closure) (CLK-100) - User Guide Click 104 (4-channel DIN rail contact closure) (CLK-104) - User Guide Click 110 (4-channel contact closure eurocard) (CLK-110) - User Guide Click 112 (detector rack card) (CLK-112) - User Guide Click 114 (detector rack card) (CLK-114) - User Guide Click 120 (screw terminal relay) (CLK-120) - User Guide Click 121 (spring cage relay) (CLK-121) - User Guide Click 200 (surge suppression) (CLK-200) - User Guide Click 201 (1 amp AC to DC converter) (CLK-201) - User Guide Click 202 (2 amp AC to DC converter) (CLK-202) - User Guide Click 203 (UPS and battery) (CLK-203) - User Guide Click 204 (4 amp AC to DC converter) (CLK-204) - User Guide Click 210 (AC circuit breaker) (CLK-210) - User Guide Click 211 (AC outlet) (CLK-211) - User Guide Click 221 (DC surge protector) (CLK-221) - User Guide Click 222 (system surge protector) (CLK-222) - User Guide Click 223 (dual-485 surge protector) (CLK-223) - User Guide Click 230 (AC surge protector) (CLK-230) - User Guide Click 250 (wireless surge protector) (CLK-250) - User Guide