Wavetronix Click 201 (1 amp AC to DC converter) (CLK-201) - Quick-reference Guide - Manual

Click Power Plant
INSTALLER QUICK-REFERENCE GUIDE
www.wavetronix.com
801.734.7200
2
Mount the devices
WARNING. Make sure power to AC mains is disconnected before wiring any of the Click modules.
Mount each power plant device onto the DIN rail by
hooking the lip over the edge of the DIN rail and using a
rocking motion to snap the module into place.
1
Identify the components
The following are included
in the Click power plant:
An authorized technician should perform installation and operation of these units. Persons other than
authorized and approved electrical technicians should NOT attempt to install the power plant, as there is
a serious risk of electrical shock through unsafe handling of the power source. Extreme caution should be
used when connecting these units to an active power supply.
One of the following power supplies will be included in the Click
power plant:
Click 210
Circuit Breaker
Click 230
AC Surge
Click 201
AC to DC converter
Click 202
AC to DC converter
Click 204
AC to DC converter
Click 203
UPS/Battery (optional)