Installation, Wiring power and communication – Wavetronix Click 400 (900 MHz radio) (CLK-400) - User Guide User Manual
Page 222
CHAPTER 26 • CLICK 330/331 221
Status
Meaning
On
Supply voltage is in an acceptable range
Off
Supply voltage is too low
Table 25.1 – Power Monitor LEDs
˽
Each Ethernet port has two LEDs that show the data transmission speed of that port,
as shown in Table 25.2. These LEDs are labeled 100/ACT and 1000/ACT. If the LED
is on, there is an electrical link. If the LED blinks, there is currently network traffic at
that speed.
LED
10 Mbps
100 Mbps
1000 Mbps
100/ACT
On or blinking
On or blinking
Off
1000/ACT
On or blinking
Off
On or blinking
Table 25.2 – Ethernet Port Monitor LEDs
˽
The fiber ports on the Click 331 each have an LED labeled 1000 LNK/ACT. If this LED
is on, there is a valid connection through that port. If the LED blinks, there is currently
network traffic at 1000 Mbps.
Installation
Unlike many other Click devices, the Click 330/331 do not mount over the T-bus, meaning
that power and communications will have to be wired in.
Wiring Power and Communication
The first four screw terminals, marked US1, GND, US2 and GND, are for wiring in power.
The other two, which are labeled R1 and R2, are for security and functionality alarm pur-
poses (see Figure 25.3).
Figure 25.3 – Wiring the Click 330/331
- Click 421 (bluetooth to serial converter) (CLK-421) - User Guide Click 342 (lean managed ethernet switch) (CLK-342) - User Guide Click 341 (lean managed ethernet switch) (CLK-341) - User Guide Click 340 (lean managed ethernet switch) (CLK-340) - User Guide Click 331 (unmanaged ethernet switch) (CLK-331) - User Guide Click 330 (unmanaged ethernet switch) (CLK-330) - User Guide Click 304 (RS-232 to RS-485 converter) (CLK-304) - User Guide Click 305 (RS-232 to RS-485 converter) (CLK-305) - User Guide Click 301 (serial to ethernet converter) (CLK-301) - User Guide Click 100 (16 output contact closure) (CLK-100) - User Guide Click 104 (4-channel DIN rail contact closure) (CLK-104) - User Guide Click 110 (4-channel contact closure eurocard) (CLK-110) - User Guide Click 112 (detector rack card) (CLK-112) - User Guide Click 114 (detector rack card) (CLK-114) - User Guide Click 120 (screw terminal relay) (CLK-120) - User Guide Click 121 (spring cage relay) (CLK-121) - User Guide Click 200 (surge suppression) (CLK-200) - User Guide Click 201 (1 amp AC to DC converter) (CLK-201) - User Guide Click 202 (2 amp AC to DC converter) (CLK-202) - User Guide Click 203 (UPS and battery) (CLK-203) - User Guide Click 204 (4 amp AC to DC converter) (CLK-204) - User Guide Click 210 (AC circuit breaker) (CLK-210) - User Guide Click 211 (AC outlet) (CLK-211) - User Guide Click 221 (DC surge protector) (CLK-221) - User Guide Click 222 (system surge protector) (CLK-222) - User Guide Click 223 (dual-485 surge protector) (CLK-223) - User Guide Click 230 (AC surge protector) (CLK-230) - User Guide Click 250 (wireless surge protector) (CLK-250) - User Guide