Wavetronix Click 400 (900 MHz radio) (CLK-400) - User Guide User Manual
Page 58
CHAPTER 7 • CLICK 101
57
Figure 7.6 – Expert Driver Comm Tab
Setting
Description
Baud Rate
Allows you to change the baud rate for both the RS-485 and RS-232
communication ports.
Flow Control
Is used for configuring hardware handshaking. This option is currently
not available.
Parity
Allows you to set parity error checking.
Stop Bits
Allows you to set the number of stop bits.
Data Bits
Shows you the number of data bits being sent. This option currently
cannot be changed.
Active Port
Indicates on which port you are communicating with one of the sen-
sors on the multi-drop RS-485 bus. When you communicate to more
than one sensor, the port may be different on each sensor. To change
the connection port, you will have to physically change the connection
of the communications link.
Latency
Indicates the latency between the sensor and the Click device. This
option cannot be changed.
Table 7.3 – Expert Driver Comm Tab
The System > Autobaud tab allows you to configure how the device autobauds (see Figure
7.7 and Table 7.4).
- Click 421 (bluetooth to serial converter) (CLK-421) - User Guide Click 342 (lean managed ethernet switch) (CLK-342) - User Guide Click 341 (lean managed ethernet switch) (CLK-341) - User Guide Click 340 (lean managed ethernet switch) (CLK-340) - User Guide Click 331 (unmanaged ethernet switch) (CLK-331) - User Guide Click 330 (unmanaged ethernet switch) (CLK-330) - User Guide Click 304 (RS-232 to RS-485 converter) (CLK-304) - User Guide Click 305 (RS-232 to RS-485 converter) (CLK-305) - User Guide Click 301 (serial to ethernet converter) (CLK-301) - User Guide Click 100 (16 output contact closure) (CLK-100) - User Guide Click 104 (4-channel DIN rail contact closure) (CLK-104) - User Guide Click 110 (4-channel contact closure eurocard) (CLK-110) - User Guide Click 112 (detector rack card) (CLK-112) - User Guide Click 114 (detector rack card) (CLK-114) - User Guide Click 120 (screw terminal relay) (CLK-120) - User Guide Click 121 (spring cage relay) (CLK-121) - User Guide Click 200 (surge suppression) (CLK-200) - User Guide Click 201 (1 amp AC to DC converter) (CLK-201) - User Guide Click 202 (2 amp AC to DC converter) (CLK-202) - User Guide Click 203 (UPS and battery) (CLK-203) - User Guide Click 204 (4 amp AC to DC converter) (CLK-204) - User Guide Click 210 (AC circuit breaker) (CLK-210) - User Guide Click 211 (AC outlet) (CLK-211) - User Guide Click 221 (DC surge protector) (CLK-221) - User Guide Click 222 (system surge protector) (CLK-222) - User Guide Click 223 (dual-485 surge protector) (CLK-223) - User Guide Click 230 (AC surge protector) (CLK-230) - User Guide Click 250 (wireless surge protector) (CLK-250) - User Guide