beautypg.com

Wiring rs-485 from a click device – Wavetronix Click 400 (900 MHz radio) (CLK-400) - User Guide User Manual

Page 24

background image

CHAPTER 3 • WIRING THE DEVICES

23

Note

If you are using a Click 200 in your installation, it is recommended you wire RS-485
through it if you would like to connect to a Click device.

Figure 3.2 – Wiring RS-485 Communication into the Click 200

Wiring RS-485 from a Click Device

Several Click devices—such as the 104, 110, 112/114, 172/174, 200, 301 and 304—also have

RJ-11 jacks for RS-485 communication with a computer or with contact closure cards. To

use, simply use an RJ-11 jumper cable to connect the two devices.

Figure 3.3 – A Click Device Showing RJ-11 and DB-9 Jacks

This manual is related to the following products: